WE ARE MAKERS TIER
Okay guys, these horror helmet ideas are getting better and better, and I'm having way too much fun with this!
So, here's the next one!
I actually had this design planned the moment i made the first one. I only mentioned it in a few comments and didn't really announce it properly because I wasn't sure if I'd be happy with how it would turn out. But now that it's finished, I'm genuinely happy with this one :)
The idea was to make it look like Jason basically ripped the Iron Man faceplate right off and slapped his own improvised Iron Man/Jason faceplate onto the helmet. I wanted it to look rough, brutal, and like it was put together by Jason himself, and I'm really happy with how it turned out!
I also didn't want to make the neck opening ridiculously huge just to get the helmet on, so the helmet is split into two parts that connect with magnets. Just separate them, put the helmet on, snap everything back together, and you're good to go.
And of course, there's a multicolor 3MF for the red parts of the mask, along with all the usual goodies. STL, pre-split parts, pre-supported files, everything ready to go. Open, select, print. No messy geometry or unnecessary headaches!
Now, the big question is... what are we doing next guys ? :)